Info
Info
News Article

Faster And Cheaper Way To Make Patterned Metals For Solar Cells And Electronics

News

An example of a patterned metal made using the new technique

An innovative way to pattern metals has been discovered by scientists in the Department of Chemistry at the University of Warwick, which could make the next generation of solar panels more sustainable and cheaper.

Silver and copper are the most widely used electrical conductors in modern electronics and solar cells. However, conventional methods of patterning these metals to make the desired pattern of conducting lines are based on selectively removing metal from a film by etching using harmful chemicals or printing from costly metal inks.

Scientists from the Department of Chemistry at the University of Warwick, have developed a way of patterning these metals that is likely to prove much more sustainable and cheaper for large scale production, because there is no metal waste or use of toxic chemicals, and the fabrication method is compatible with continuous roll-to-roll processing.

The work is reported in the paper ‘Selective deposition of silver and copper films by condensation coefficient modulation' published in the journal Materials Horizons.

Thanks to £1.15 M funding from the UK Engineering and Physical Sciences Research Council, Dr Ross Hatton and Dr Silvia Varagnolo have discovered that silver and copper do not condense onto extremely thin films of certain highly fluorinated organic compounds when the metal is deposited by simple thermal evaporation.

Thermal evaporation is already widely used on a large scale to make the thin metal film on the inside of crisp packets, and organofluorine compounds are already common place as the basis of non-stick cooking pans.

The researchers have shown that the organofluorine layer need only be 10 billionths of a metre thick to be effective, and so only tiny amounts are needed.

This unconventional approach also leaves the metal surface uncontaminated, which Hatton believes will be particularly important for the next generation sensors, which often require uncontaminated patterned films of these metals as platforms onto which sensing molecules can be attached.

To help address the challenges posed by climate change, there is a need for colour tuneable, flexible and light weight solar cells that can be produced at low cost, particularly for applications where conventional rigid silicon solar cells are unsuitable such as in electric cars and semi-transparent solar cells for buildings.

Solar cells based on thin films of organic, perovskite or nano-crystal semiconductors all have potential to meet this need, although they all require a low cost, flexible transparent electrode. Hatton and his team have used their method to fabricate semi-transparent organic solar cells in which the top silver electrode is patterned with millions of tiny apertures per square centimetre, which cannot be achieved by any other scalable means directly on top of an organic electronic device.

Dr Hatton from the Department of Chemistry at the University of Warwick comments:

“This innovation enables us to realise the dream of truly flexible, transparent electrodes matched to needs of the emerging generation of thin film solar cells, as well as having numerous other potential applications ranging from sensors to low-emissivity glass.”


Researchers from left to right: Dr Ross Hatton, Dr Silva Varagnolo and Dr Jaemin Lee

US Solar Fund To Acquire Up To 50% Of 200MWDC Mount Signal 2
SunBrush Mobil And Infinity Establish Service Base At Benban, Africa's Largest Solar Park
Sonnedix Brings Chile Closer To Meet Its Renewable Power Targets
Greencoat Renewables Announces First Transaction In Nordic Market
Solar Energy For Water Treatment: IBC SOLAR Helps Water Authority Become More Sustainable
International Solar Alliance Special Assembly Elects Dr Ajay Mathur As New Director General
Sonnedix Adds 40 MW Of Capacity To Its Portfolio In Chile
VivoPower International PLC Announces Completion Of Electrical Works For 39 MWdc Molong Solar Farm
Q CELLS Solar Modules Keeping The Lights On For Dutch Bulb Grower
Sonnedix Acquires 150MW Utility Scale Project Located In Central Chile
Ib Vogt Achieves Financial Close And Start Of Construction Of 116 MWp Solar PV Project In Malaysia
SolarArise Commissions 75 MW Solar Plant In Uttar Pradesh
Oakapple Renewable Energy Appoint Stuart Gentry To Head Business Development
SUNfarming Reaches Financial Close On Project Financing For 26 MWp PV Portfolio In Poland
Winch Energy Closes Largest Mini Grid Financing Portfolio To Date
Leclanché Selected By ENERGODATA To Provide Battery Storage
The Smarter E South America Postponed To October 18-20, 2021
AEG Power Solutions Equips The Microgrid Laboratory Emulator Of Paderborn University
BayWa R.e. And HeidelbergCement Sign First Solar Corporate PPA In Polish History
Luxcara And GE Renewable To Deliver 753 MW To Sweden With Single Onshore Wind Farm
SUNfarming Secures EUR 10 Million In Fresh Money For Poland
Analysis Of UK Commercial Roof Space Shows Solar PV Film Can Achieve Net Zero Without Greenfield Sites
Going Green In Lancashire – Hundreds Of Houses Installed With Solar Panels In Ground-breaking Project
Driving Efficiency Through Flexible Solar Power Solutions

×
Search the news archive

To close this popup you can press escape or click the close icon.
Logo
×
Logo
×
Register - Step 1

You may choose to subscribe to the Solar + Power Magazine, the Solar + Power Newsletter, or both. You may also request additional information if required, before submitting your application.


Please subscribe me to:

 

You chose the industry type of "Other"

Please enter the industry that you work in:
Please enter the industry that you work in:
 
X
Info
X
Info
{taasPodcastNotification} Array
Live Event